Wednesday, February 11, 2009

Ubuntu Network Adaptor

If you have an additional network adaptor or need to change the ip address of an adaptor follow these command to change the information.

Modify: /etc/network/interfaces
auto eth0
iface eth0 inet static
        address 10.10.1.101
        netmask 255.255.255.0
        network 10.10.1.0
        broadcast 10.10.1.255
        gateway 10.10.1.1
        # dns-* options are implemented by the resolvconf package, if installed
        dns-nameservers 10.10.1.250
        dns-search domainname.com

Setting up the DNS service, modify: /etc/resolv.conf
search domainname.com
nameserver 10.10.1.250
nameserver 66.35.209.135

Modify the hosts file in /etc/hosts
127.0.0.1          localhost
10.10.1.101     subdomain.domainname.com subdomain
# The following lines are desirable for IPv6 capable hosts
::1     localhost ip6-localhost ip6-loopback
fe00::0 ip6-localnet
ff00::0 ip6-mcastprefix
ff02::1 ip6-allnodes
ff02::2 ip6-allrouters
ff02::3 ip6-allhosts

After this has been changed then restart the network adapter.
sudo /etc/init.d/networking restart

No comments:

Post a Comment

Raspberry Pi Zero W - Wireless Configuation

create the file under "boot" folder wpa_supplicant.conf country=GB ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev u...